LUBRICANTS > DRAWING
Non reactive salt at low borax content. it is mainly applied in preparation of stainless steel rods to drawing processes
DOWNLOAD TECHNICAL
REQUEST MORE INFORMATION
Traditional non reactive salt with borax. it is mainly applied in preparation of stainless steel rods to drawing processes
DOWNLOAD TECHNICAL
REQUEST MORE INFORMATION
Non reactive salt, free of Boron and its derivates
DOWNLOAD TECHNICAL
REQUEST MORE INFORMATION
Drawing lubricant. It does not leave any residuals or stains after annealing. Easy to remove.
DOWNLOAD TECHNICAL
REQUEST MORE INFORMATION
Additivated copper sulfate for chemical coppering of steel wire.
DOWNLOAD TECHNICAL
REQUEST MORE INFORMATION
Synthetic, water soluble lubricant for wet drawing of wires of any metal.
DOWNLOAD TECHNICAL
REQUEST MORE INFORMATION
Classic reactive oil based on polyphosphoric acids
DOWNLOAD TECHNICAL
REQUEST MORE INFORMATION
Chlorine free synthetic lubricant for drawing of carbon steel rods and tubes.
DOWNLOAD TECHNICAL
REQUEST MORE INFORMATION
Chlorine free, synthetic lubricant for drawing of high alloys and stainless steel rods and tubes.
DOWNLOAD TECHNICAL
REQUEST MORE INFORMATION
Special fluid with additives, designed for Yellow alloys drawing, extrusion and stamping. Condorlube TR 4 SB contains protectives and inhibiting additives.
DOWNLOAD TECHNICAL
REQUEST MORE INFORMATION
Mineral oil and esters based oil for drawing of copper and its alloys profiles.
DOWNLOAD TECHNICAL
REQUEST MORE INFORMATION